Parallel Jaw Grip, 0.7 to 1.3-Inch HDPE Wire

This Parallel Jaw grip was specifically designed to securely pull slippery HDPE-coated cable or tree wire. The innovative high-traction surface grips the cable without damaging the outer jacket. The tough carbide grit technology withstands even the harshest jobsite conditions. The grip is spring-loaded for one-handed operation and easy placement on the conductor.

• Securely pulls HDPE-coated cable commonly known as tree wire
• Innovative high-traction surface grips the cable without damaging the outer jacket; pulls cable diameters 0.7 to 1.3-Inch (1.8 to 3.3 cm)
• Tough carbide grit technology withstands even the harshest jobsite conditions
• Spring-loaded for one-handed operation and easy placement on the conductor
• Made in USA
• Common tree wire cable types include General Cable, Hendrix® aerial systems, Rite Lite BLL conductor and Southwire S2 covered cable
• Hendrix® is a registered trademark of Marmon Utility, LLC
• Southwire® is a registered trademark of Southwire Company, LLC

• Warning: Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.
• Warning: When used on/near energized lines, ground, insulate, or isolate grip before pulling.
• Warning: Do not exceed rated capacity.
• Warning: Do not exceed rated capacity.
• Cable Diameter: 0.7" to 1.3" (17.78 to 33.02 mm)
• Type: Parallel Jaw Grip
• Weight: 8.1 lb (3.7 kg)
• Maximum Safe Load: 12,000 lb (5443 kg)
• Jaw Length: 5.125" (13 cm)
• Cable Type: HDPE-Coated
• Jaw Type: Round
• Hot Latch: N
• Spring: Y
• Locking Handle: N
• Size_Name: 1-Pack
• Swing Latch: N

Datasheet

Instructions

Video