Parallel Jaw Grip - Lock, HDPE Wire to 1.362-Inch

This parallel jaw grip was specifically designed to securely pull slippery HDPE-coated cable or tree wire. The innovative high-traction surface grips the cable without damaging the outer jacket. The tough carbide grit technology withstands even the harshest jobsite conditions. The grip is spring-loaded for one-handed operation and easy placement on the conductor.

• Securely pulls HDPE-coated cable commonly known as tree wire
• Innovative high-traction surface grips the cable without damaging the outer jacket
• Locking handle keeps jaw open while using hot stick to place grip on cable
• Pulls cable diameters 0.625-Inch to 1.362-Inches (15.9 to 35.0 mm)
• 4,000-Pound (1814 kg) maximum safe load
• Tough carbide grit technology withstands even the harshest jobsite conditions
• Spring-loaded for one-handed operation and easy placement on the conductor
• Common tree wire cable types include general cable, Hendrix® aerial systems, rite lite BLL conductor and Southwire® S2 covered cable
• Hendrix® is a registered trademark of Marmon Utility, LLC
• Southwire® is a registered trademark of Southwire Company, LLC

• Warning: Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.
• Warning: When used on/near energized lines, ground, insulate, or isolate grip before pulling.
• Warning: Do not exceed rated capacity.
• Warning: Do not exceed rated capacity.
• Overall Width: 6.975" (7 cm)
• Cable Type: HDPE-Coated
• Jaw Length: 4.5" (11.4 cm)
• Weight: 5.10 lb (2.3 kg)
• Overall Height: 8.5" (21.6 cm)
• Special Features: High Traction Grip Surface, Lock
• Type: Parallel Jaw Grip
• Cable Diameter: 0.625" to 1.362" (15.9 to 34.6 mm)
• Application: Wire Pulling
• Material: Forged Steel
• Standard: OSHA
• Jaw Type: Round
• Spring: Y
• Overall Length: 13.05" (17.7 cm)
• Locking Handle: Y
• Maximum Safe Load: 4000 lb (1814 kg)
• Hot Latch: Y
• Swing Latch: N

Datasheet

Video